Tech Rider for the Flyin’ Bob Show Lighting Theatre Stage - general wash, with back lighting. House - lights at 50% throughout the performance. House lights to go up to 75% when performer is in the audience. Theater to go to black on cue. Two lighting cues. Performer will supply black light School Gym Existing lighting. Sound Performer will supply: Samson Airliner wireless vocal headset and receiver CD. Music cues for CD Handheld mike and cord PA System if requested Stage Space Performance area: 25’ x 15’ minimum. Vertical height required: 18’ minimum. Electrical AC power near stage. Power for headset receiver. Receiver to be placed near stage. Dressing Room A place to change and do warm up for one person. Tightwire Set Up Theatre Stage Anchoring points for tightwire: one on either side of stage 30 ft from stage center. Anchoring points can be off stage. Support cables can tie off to objects off stage, e.g. pin rail, railings, forklift, support beams, columns, door frames, etc. Performer will also provide metal plates for attachment points that can be secured to the floor using 11/4 inch lag bolts. School Gym Floor Performer will provide tightwire anchors that fit into volleyball pole holes in the gym floor. Props Tightwire and/or 6 foot unicycle Juggling and balance props One prop case Black light Set up time Initial set up: 2 - 3 hours Before each show: 5 – 10 minutes Strike time Strike from stage: 10 minutes Pack the show: one and a half hours Crew required one